CHM/110 v7
Week 3 Assignment Guide
CHM/110 v7
Page 2 of 2
Week 3 Assignment Guide
Use the following guide to help you complete the Week 3 simulation.
Visit the Acid-Base Solutions Simulation and then complete the following steps.
Click My Solution from the home screen.
Above the container, to the right, there is a pH meter. Drag and drop it into the solution to obtain an initial measurement. The initial reading should have a pH of 4.50.
Increase and decrease the arrows beneath Initial Concentration. Observe what happens to the solution and note how the pH changes.
Adjust the Strength of the solution by dragging the slider between “weaker” and “stronger.” Observe what happens to the solution and note how the pH changes.
Near the top right of the screen, switch the toggle from “Acid” to “Base.” Repeat your steps and observe what happens.
Copyright 2022 by University of Phoenix. All rights reserved.
Copyright 2022 by University of Phoenix. All rights reserved.